How to effectively avoid clogging of superfine pulverizer

How to avoid clogging and improve the efficiency of the ultramicro pulverizer? So operators need to pay attention to what can avoid clogging and reduce failures in the process of use, so as to improve the efficiency. Let's have a look!

In our daily life, there are a lot of pulverizers, ultramicro pulverizers, universal pulverizers, etc., but in the process of use, sometimes there are some failures, and sometimes the pulverizer is blocked. When it is blocked, how should we deal with it? In fact, blockage is a common fault of the pulverizer during crushing, and the main reason is improper operation. Today, I will teach you some methods to deal with the jam of the superfine pulverizer.

1. If the feeding speed is too fast, the load will increase, causing blockage. During the feeding process, pay attention to the large deflection angle of the ammeter pointer at any time. If the current exceeds the rated current, it indicates that the motor is overloaded. If the motor is overloaded for a long time, it will burn out the motor. In this case, the feeding door should be reduced or closed immediately, or the feeding mode can be changed, and the feeding amount can be controlled by increasing the feeder. There are two types of feeders: manual feeder and automatic feeder. The user should select the appropriate feeder according to the actual situation. Because of the high speed, large load and strong fluctuation of the load of the crusher. Therefore, the current of the pulverizer is generally controlled at about 85% of the rated current.

2. The outlet pipe is blocked or the feeding is too fast, which will block the air outlet of the pulverizer; Improper matching with the conveying equipment will cause the discharge pipe to become weak or blocked when there is no wind. After the fault is found, the unmatched conveying equipment shall be cleaned and the feeding amount shall be adjusted to ensure the normal operation of the equipment.

3. Broken and aged hammers, closed and broken screen holes, and high water content of crushed materials will block the crusher. Broken and severely aged hammers shall be renewed regularly to keep the pulverizer in good working condition, and the screen mesh shall be checked regularly. The moisture content of crushed materials shall be lower than 14%, which can not only improve the production efficiency, but also make the pulverizer not blocked, and enhance the reliability of the pulverizer.

These are the ways to deal with the jam of the ultramicro pulverizer. It is very common for the machine to break down. The most important thing is that we should know the way to solve the problem. This is a factor that makes the use of the pulverizer longer. In addition, it is also very important to maintain the machine.