Possible problems in the use of traditional Chinese medicine superfine pulverizer

We all know that the traditional Chinese medicine superfine pulverizer has several prominent characteristics, that is, it has strong adaptability, high crushing yield ratio and relatively low crushing temperature. The grinding mechanism of the crusher mainly determines its wide application range and high fineness of finished products.

Typical materials include: superhard diamond, silicon carbide, metal powder, etc., high purity requirements: ceramic pigment, medicine, biochemistry, etc., and low temperature requirements: medicine and PVC. The materials of the air flow crusher enter the cylindrical crushing chamber through the feeding port, and are crushed by the grinding wheel moving circularly along the grinding rail.

As we all know, there are more or less problems in the use of mechanical equipment. What problems will occur in the operation of traditional Chinese medicine ultra-fine pulverizer?

Xiaobian listed the common problems for you, or stones, iron blocks and other hard objects enter the machine, improper adjustment of the reverse injection damper at the feed inlet, blocking of the conveying pipe, blocking of the screen hole, too short or poor air permeability of the powder collection bag, severe wear of the edge of the hammer (a basic type of failure of parts) and so on.

The materials of the air flow crusher enter the cylindrical crushing chamber through the feeding port, and are crushed by the grinding wheel moving circularly along the grinding rail. When the bearing is too hot, the bearing belt is too tight or the rotor is damaged.

The traditional Chinese medicine superfine pulverizer caused a great sensation, there was abnormal sound damage in the pulverizer, and the parts in the pulverizer were damaged and dropped. In case of abnormal sound, stop the machine immediately for inspection, replace the damaged parts or take out the hard objects. Low production power (refers to the amount of work done by the object in unit time) the main reasons for low production power are lack of motor power, improper manufacture of belt pulley, belt slip, severe wear of hammer (a basic type of component failure), uneven feeding or high water content of material. In the glass flake coating after construction, the flat glass flakes with an aspect ratio of 30-120 are in a palace structure of parallel overlapping arrangement in the resin, so as to form a dense impervious layer structure. The penetration of corrosive medium into the cured resin must go through countless tortuous ways. Therefore, in the corrosion resistant layer with a certain thickness, the distance of corrosion penetration is greatly extended, which is equivalent to effectively increasing the thickness of glass flake anti-corrosion layer.