This should be done when the jet mill is started in order to troubleshoot

This should be done when the jet mill is started to eliminate the fault

The jet mill can pulverize the raw materials into ultra-fine powder, and then continue to sieve the fine powder into coarse powder, fine powder and ultra-fine powder of different particle size grades. The surface area of the raw material after processing by the jet mill becomes larger, which further improves the raw material The physical effect or the speed of chemical reaction, thereby increasing its application value. For example, after the catalyst and adsorbent are crushed to ultrafine level, they can be enhanced
The medium efficiency and adsorption effect, the coal block is ground into pulverized coal to improve its combustion speed and combustion degree.

The crushing mechanism that the jet mill is mainly suitable for determines its wide application range and high fineness of the finished product. It is widely used in chemicals, minerals, metallurgy, abrasives, ceramics, refractory materials, medicine, pesticides, food, health products, new materials, etc. industry. Therefore, there are many people who use it, and the advantages it brings to people are also very large. After learning its maintenance methods and also learning its maintenance methods, do you know what to do when the jet mill is started? Let's take a look with the editor below.

Before starting the jet mill, first roll the rotor by hand to check whether the jaws, hammers and rotor work flexibly and reliably, whether there are bumps in the shell, and whether the direction of rotation of the rotor is consistent with the direction indicated by the arrow of the machine. The smoothness of the grinder is not outstanding. Do not replace the pulley at will, in case the speed is too high to cause explosive smashing in the crushing chamber, or the speed is too low to affect the operating efficiency of the crusher.
       After starting the jet mill, it should be idling for 2-3 minutes, and there is no abnormal appearance before feeding. Pay attention to the working condition of the crusher at all times during the operation, and the feeding must be even to prevent the stuffy car from being blocked, and do not overload the work for a long time. If there are signs of vibration, noise, excessive temperature of the bearing and the body, or spraying materials, the machine should be shut down immediately for inspection, and the operation can be continued after troubleshooting.